On taking a closer look i noticed that water was dripping from the hot water outlet connection.
Truma water heater problems.
My model has settings at 500w 1kw and 2kw.
Maximum of 65 psi 4 5 bar.
Truma hot water systems are used world wide so this helpful video should assist anyone that has one of these systems.
Most truma hot water systems have a small 10 amp.
I have recently had one fail on a truma system that was less than 9 months old.
If the water system is connected to a cen.
Water escaping at pressure relief.
Perhaps the truma guys will chime in here.
If the relays are faulty this can reduce the power of the heater.
They are known to fail for no apparent reason.
However the aqua go has a small tank in it which will likely reduce temperature swings compared to other tankless water heaters.
Truma water heater problems.
The truma aquago basic does not have frost protection and should not be used or filled with water when there is a danger of freezing.
Ceramic slow blow fuse fitted on the control pcb.
The unit has worked without further problems following replacement of the fuse.
I first noticed the problem when the carpet near the boiler door seemed to be wet.
Search for other brands on my channel.
Water pressure in water system too.
Tral water supply higher than 65 psi 4 5 bar rural or urban connection a pressure reducer must be used.
Adjust the water pump pressure to a.
Manuals instructions installation and operating instructions truma aquago basic comfort comfort plus 7 55 mb.