Sunsetter Awning Remote Flashes Red Light

If not replace the cr2430 battery.

Sunsetter awning remote flashes red light.

Press the neutral middle button on the transmitter. The multi channel remote transmitter must be programmed to the light control box the first time the led light system is plugged in. Verify that the red light on the remote transmitter comes on when you press and hold the button. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.

If it does continue to the next step. Electric drill use gloves and eye protection center punch hammer pencil tape measure. If not replace the cr2430 battery. Press and hold my for 8 seconds the light should blink the entire time.

The awnings are operated with buttons on the motor control or by a remote control. Manual motor control bar. If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15.